Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TOURING RALLYE RACING
01-044-0650-0
Contains:
1 x Side stand extension plates:
Ground plate
Middle plate
Top plate
4 x Screw counter sunk M5x16
4 x Nzlock nut M5
4 x Washer M5
INSTALLATION:
With the bike on the centerstand, and the
sidestand down, position the ground
plate with the "45degree corner" towards
the inside rear.
Set the middle plate on the ground plate
aligned similarly and set then the side
stand in the middle of those two plates.
Align the top plate and attach all three
plates with supplied countersunk screws
from the bottom. Place the the washers
and nylock nut on the top as shown on
photos.
FRONT OF MOTORCYCLE
hese instructions are at our current level of knowledge. Legal requirements do not exist. Technical issues subject to change.
Installation Instructions
Side Stand Extension Plate R1200GS
Ground plate
CUT CORNER -
INSIDE REAR
TECHNOLOGY
Top plate
Middle plate
Check the strenght of
the spring in regular
intervals to make sure
side stand stays up.
For Off-Road use it is
recommended that
the BMW rubber
sidestand stop is cut
in half to increase
ground clearance.
Werbung
