Lionelo Liam Color Handbuch Seite 35

7.1.1. Adjust the back of the safety seat so that it is in the position
number 1 or 2.
7.1.2. Install the safety seat in a forward-facing position, in a car
equipped with 3-point seat belts.
7.1.3. First, pull the vehicle' s seat belts as much as possible.
7.1.4. Run the lap belt and the shoulder belt through the safety seat
EN
(Picture 7.01, 7.02). Thread the lap belt through the "C" hole and pull it out
of the "D" hole at the other side. At the same time carry the shoulder belt
through the special hole behind the back of the safety seat.
7.1.5. Ensure that the vehicle' s seat belt connector is properly locked in a
buckle.
7.1.6. Ensure that the vehicle' s seat belts are not twisted.
7.1.7. Belt positions must be identical as shown in the picture below,
including fixing points.
7.2. Securing a child with the 5-point safety harness
7.2.1. Choose the most appropriate slots and run the shoulder
straps through them. The slots position should be determined by
the height of the child.
7.2.2. Place your child in the safety seat.
7.2.3. Secure the child with the 5-point safety harness.
7 . 2 . 4 . E n s u re t h a t t h e s t ra p s a r e n o t t w i s t e d .