Enabling A Computer To Make Network Connections; Monitoring And Controlling Projectors - Epson EMP-765 Installationshandbuch

Connecting in Access Point Mode or Wired LAN Mode

Monitoring and Controlling Projectors

The following functions can be used to monitor and control projectors from a
computer over a network (when using either a wireless LAN or a wired LAN).
• Mail Notification Function
The mail notification function can be used to send notification messages to preset
e-mail addresses when a problem occurs with a projector, in order to notify
somebody of the problem. Select "Network" - "Mail" to make the mail
notification function settings.
s"Using the Mail Notification Function to Report Problems" in the EasyMP
Operation Guide
• SNMPg Function
The SNMP function can be used to send warning notifications to preset
computers when a problem occurs with a projector, in order to notify somebody
of the problem. Select "Network" - "SNMP" to make the SNMP settings.
s"Management Using SNMP" in the EasyMP Operation Guide
Tip :
The SNMP function to monitor the projector requires SNMP Manager to be installed
in the computer. Because of this, management using SNMP should always be carried
out by somebody who is familiar with computer networks such as a network
administrator.
• Monitoring and Control Functions Using EMP Monitor
You can use the EMP Monitor program that is contained in the EasyMP Software
CD-ROM that is included with the projector to monitor the statuses of up to a
maximum of 64 projectors that are connected to the network. This lets you carry
out centralised monitoring and control of multiple projectors using a single
computer.
Installing EMP Monitor sp.17
Using EMP Monitor sEMP Monitor Operation Guide

Enabling a Computer to Make Network Connections

These settings make it possible for a computer to be used to add projectors to a
network (LAN).
If these settings are already established, this step need not be performed.
38