Epson EMP-765 Installationshandbuch Seite 37

Connecting in Access Point Mode or Wired LAN Mode
Projector
keyword
DHCP
IP addressg
Subnet mask
Gateway
address
MAC address
* The item contents will be cleared if you select the "Clear" button on the
selected item and press [Enter] on the remote control.
36
If the projector keyword option is set to "ON", keyword entry
will be required when connecting to the projector over a
network. By using this method, you can prevent other
unauthorised computers from connecting to the network and
interfering with the presentation.
This option should normally be "ON".
g
Indicates DHCP use.
"ON" : enables DHCP
"OFF" : disables DHCP
Enter the IP address assigned to the projector.
Numbers between 0-255 can be input for each of the fields
of the address. However, the following IP addresses
cannot be used. 0.0.0.0, 127.x.x.x, 224.0.0.0-
255.255.255.255 (where x is a number between 0-255)
g
Enter the subnet mask for the projector.
Numbers between 0-255 can be input for each of the fields
of the address. However, the following subnet masks
cannot be used. 0. x.x.x-254.255.255.255,
255.255.255.255 (where x is a number between 0-255)
g
Enter the gateway IP address for this projector. Numbers
between 0-255 can be input for each of the fields of the
address. However, the following gateway addresses cannot
be used. 0.0.0.0, 127.x.x.x, 224.0.0.0-255.255.255.255
(where x is a number between 0-255)
g
Displays the MAC address of the LAN card installed in
the projector. If there is no LAN card installed, the MAC
address will be displayed as "00:00:00:00:00:00".