Transport; Storing The Device; Maintenance And Care - Kärcher KMR 1250 BAT Bedienungsanleitung

Note
An optimum cleaning result can only be
achieved if the bulk waste flap has been
lowered completely.
Sweeping dry floors
Lower the roller brush while cleaning
surfaces.
Lower side brush when cleaning along
edges.
Note
Roller brush and side brush start operating
automatically.
Switch on dust suction while cleaning dusty
surfaces.
Switch on the blower.
Sweeping damp or wet floors
Switch off the dust suction to protect the
dust filter against moisture.
Switch off the blower.
Emptying waste container
Danger
Risk of injury! When emptying the waste
container, care should be taken to ensure
that no persons or animals are within its
swivelling range.
Danger
Danger of crushing. Never reach into the
rod assembly for the drainage mechanism.
Stay away from the area under the raised
container.
Danger
Danger of tipping. Place the machine on an
even surface during emptying.
Stop the machine.
Raise roller brush.
Note
The container can only be tilted and emp-
tied once a set minimum level has been
reached.
Note
A two-handed operation is required to carry
out the following steps.
Raise waste container.
Once the required height has been
reached:
Tip waste container out.
– The waste container can be emptied in
the easiest way in the fully drawn-out
position.
22
– If the switch for the tilting mechanism of
the waste container is released, then
the waste container automatically goes
back to the starting position.
Tilt the waste container up to the end-
position.
Turn off the appliance.
Release the accelerator pedal, the ma-
chine brakes automatically and stops.
Lock parking brake.
Raise roller brush.
The side-brushes lift up.
Turn main key to "0" and remove it.
Note
Once the machine has been switched off,
the dust filter is shaked automatically for
approx. 10 seconds.
Shutdown
If the sweeper is going to be out of service
for a longer time period, observe the follow-
ing points:
Park the sweeper on an even surface.
Raise the roller brush and the side-
brushes to prevent the bristles from be-
ing damaged.
Turn main key to "0" and remove it.
Lock parking brake.
Lock the sweeper to ensure that it does
not roll off.
Clean the inside and outside of the
sweeper.
Park the machine in a safe and dry
place.
Pull out the battery plug.
Charge battery and recharge it approx.
every 2 months.

Transport

Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
When transporting in vehicles, secure the
appliance according to the guidelines from
slipping and tipping over.
Warning
The appliance must be secured against
slippage during transport.
Turn main key to "0" and remove it.
Lock parking brake.
Secure the appliance at the transport
eyelets using tension belts, ropes or
chains.
Secure the wheels of the machine with
wheel chocks.
7
-
EN
Note
Observe markings for fixing points on base
frame (chain symbols). When loading or
unloading the machine, it may only be op-
erated on gradients of max. 18%.

Storing the device

Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Maintenance and care

General notes
– Maintenance work may only be carried
out by approved customer service out-
lets or experts in this field who are famil-
iar with the respective safety
regulations.
– Mobile appliances used for commercial
purposes are subject to safety inspec-
tions according to VDE 0701.
Cleaning
Warning
Risk of damage! Do not clean the appliance
with a water hose or high-pressure water
jet (danger of short circuits or other dam-
age).
Cleaning the inside of the machine
Danger
Risk of injury! Wear dust mask and protec-
tive goggles.
Open the device hood.
Clean machine with a cloth.
Blow through machine with com-
pressed air.
Close cover.
External cleaning of the appliance
Clean the machine with a damp cloth
which has been soaked in mild detergent.
Note
Do not use aggressive cleaning agents.