Nordcap M5 Gebrauchsanleitung Seite 12

4.3.3 Change of the SET POINT 2
1- Press the key for 1 second to display the value of the SET POINT2 ;
2 – Use the key or
3 - Press for 5 seconds to confirm the new value.
4.3.4 Change of the Diferential 1
1- Press for 5 seconds, it shows st;
2 – Press the key or
3 – Press the key to display the value of the parameter;
4 – Press the key or
5 – Press the key to confirm temporarily the new value and display the parameters code;
6 – To memorise the new value press the
4.3.5 Change of the Diferential 2
1- Press for 5 seconds, it shows st;
2 – Press the key or
3 – Press the key to display the value of the parameter;
4 – Press the key or
5 – Press the key to confirm temporarily the new value and display the parameters code;
6 – To memorise the new value press the
4.3.6 Configuration for HACCP control on the Powercompact controllers
St - set point – Working temperature.
rd – Temperature differential
AH – Highest temperature level allowed without alarm
AL – Lowest temperature level without alarm
Ad – Delay of temperature alarm
MNS00030.00
TEC
INSTRUCTIONS MANUAL
to increase or decrease the value;
till the parameter rd1;
to change the value;
key for 5 seconds.
till the parameter rd2;
to change the value;
key for 5 seconds.
y__ year
M__ month
d__ day
u_ day of the week
h__ hour
n__ minutes
t__ time of the event
Htd – period of delay of HACCP alarm
HAn, HFn – Number of HÁ and HF alarms occurred
N.º
MNS00030.00
12/12