Nordcap M5 Gebrauchsanleitung Seite 11

• Do not place heated foods inside the cabinet;
• Cover the foods with a protection to avoid damaging the evaporator.
• Do not load the shelves with more than its maximum load capacity (40 Kg).
• Do not use pointed objects to remove ice - that could damage the evaporator and be dangerous to health and environment;
• If you do not fallow the advises above, there will be an increase of electrical energy.
4.1 - Starting- up
Ensure that the plug has been introduced correctly into the socket or that the switch for the cupboard has been connected.
Then connect the cabinet, which involves – see also the enclosed electronic controller data sheet:
⇒ Press button "B", the display will flash for a few seconds until it indicates the inside temperature.
⇒ Temperature regulation is carried out automatically by electronic thermostat "A".
4.2 – Brake working instructions (option)
4.3. Powercompact microprocessor instructions
4.3.1 Definitions
Set Point – The lowest temperature in ºC inside the cabinet.
Differential – Interval of temperature in ºC for the working of the cabinet.
4.3.2 Change of the SET POINT
1- Press the key for 1 second to display the value of the SET POINT 1;
2 – Use the key or
3 - Press for 5 seconds to confirm the new value.
MNS00030.00
TEC
INSTRUCTIONS MANUAL
A – ELECTRONIC CONTROLLER - Termostat
B. - ON / OFF – Switch On / Switch Off
Brake
to increase or decrease the value;
N.º
Release the Brake
St1/St2 – SET POINT
Rd1/Rd2 – Differential
MNS00030.00
11/11