Troubleshooting - Einhell Royal KSE 2000 Bedienungsanleitung

Anleitung KSE 2000_12spr
GB

Troubleshooting

Please read the safety information on page 8 and 9.
Fault
Motor does not run
Chain does not move
Poor cutting performance
Saw works only with difficulty
Chain jumps off sword
Chain becomes hot
Never use tools with defective On/Off switches.
In the case of all other types of technical faults, please contact an authorized Customer Service workshop, our
Central Service Department, or your local dealer.
22
24.10.2001 10:46 Uhr
Cause
No electricity
Chain brake
Chain brake
Blunt chain
Chain wrongly fitted
Chain tension
Chain tension
Chain lubrication
Seite 22
Remedy
Check socket, cable and plug.
Damaged cable: Have repaired by
Customer Service. It is prohibited to patch
the cable with insulating tape.
Damaged switches have to be replaced
by a Customer Service workshop.
See section 16 and 17 „Chain brake" and
„Releasing the chain brake".
Check the chain brake, release if
necessary.
Sharpen the chain
Check that the chain is fitted correctly
Check the chain tension
Check the chain tension
Check oil level
Check chain lubrication