General Safety Instructions - Bosch TDS25 Serie Gebrauchsanleitung

Thank you for buying the sensixx B25L steam station,
the new steam-ironing system from Bosch.
Carefully read through the operating instructions for
the appliance and safeguard them for future reference.
Introduction
These instructions for use contain valuable information
about the unique features of this system and some hints to
make ironing easier for you.
This powerful system produces non-stop steam for an ideal
ironing performance. It has a large detachable water tank
that can be refilled at any time without switching off the
system.
We hope that you enjoy ironing with this steam station.
Important
Open out the first page of the booklet, this will help you to
understand how the appliance works.
This appliance complies
standards.
This appliance has been designed exclusively for domestic
use and must not be used for industrial purposes.
This appliance must only be used only for the purposes for
which it was designed, i.e. as an iron. Any other use will
be considered improper and consequently dangerous. The
manufacturer will not be held responsible for any damage
arising from misuse or improper use.

General safety instructions

• This appliance is to be connected and used in accordance
with the information stated on its characteristics plate.
• This appliance must be connected to an earthed socket.
If it is absolutely necessary to use an extension cable,
make sure that it is suitable for 16A and has a socket
with an earth connection.
• The iron should not be used if it has been dropped, if
there are visible signs of damage or if it is leaking water.
It must be checked by an authorized Technical Service
Centre before it can be used again.
• If the safety fuse fitted in the appliance blows, the
appliance will be rendered inoperative. To restore
normal operation the appliance will have to be taken to
an authorised Technical Service Centre.
• In order to avoid that, under unfavourable mains
conditions, phenomena like transient voltage drops or
lighting fluctuations can happen, it is recommended that
the iron is connected to a power supply system with a
maximum impedance of 0.27 Ω. If necessary, the user
can ask the public power supply company for the system
impedance at the interface point.
• This appliance is not intended to be used by persons
(including children) with reduced physical, sensory or
mental capacities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning the use of the appliance by a person
responsible for their safety.
• Children should be supervised to ensure that they do not
play with the appliance.
• Remove the plug from the socket before filling the
appliance with water or before pouring out the remaining
water after use.
• The appliance must never be placed directly under the
tap to fill the water tank.
with international safety
• The appliance must be used and placed on a stable
surface.
• When placed on its stand, make sure that the surface on
which the stand is placed is stable.
• The iron must not be left unattended while it is connected
to the supply mains.
• Unplug the appliance from the mains supply after each
use, or if a fault is suspected.
• The electrical plug must not be removed from the socket
by pulling the cable.
• Never immerse the iron or steam tank in water or any
other fluid.
• Do not leave the appliance exposed to weather
conditions (rain, sun, frost, etc.).
• With the aim of avoiding dangerous situations, any work
or repair that the appliance may need, e.g. replacing a
faulty mains cable, must only be carried out by qualified
personnel from an Authorised Technical Service Centre.
Important :
• This appliance reaches high temperatures and produces
steam during use, this could cause scalds or burns in
case of improper use.
• The steam hose, base station and in particular the iron
can get hot when used.
• Never aim the steam at people or animals.
• Do not allow the power cable to come into contact with
the soleplate when it is hot.
• Be aware that the system can keep on steaming a short
additional time after releasing the steam trigger. This is a
normal function.
Description
1. Removable water tank
2. Removable iron pad
3. Variable steam control*
4. Steam hose
5. Illuminated main power 0/I button
6. "Steam ready" / "Auto shut-off" pilot light
7. "Water empty" / "Clean warning" pilot light
8. Housing with internal steam generator
9. Mains plug
10. Mains cable with storage facility
11. Cord clip
12. Temperature dial
13. Iron pilot light
14. Iron´s steam release button
15. Soleplate
16. Steam gun
17. Gun´s steam release button
18. Steam concentrator
19. Brush extension
20. Diffuser extension
21. Connection plug
22. Protection cap
23. Slot position for connection
* Model dependent
en
11