Using The Cooler - Waeco CoolFreeze CF-18 Bedienungsanleitung

_CF-18_60.book Seite 39 Donnerstag, 26. Juli 2007 3:18 15
This is how to select the battery monitor mode:
CF-25, CF-35, CF-40, CF-50, CF-60
➤ Switch on the cooler.
➤ Press the "SET" button (Fig. 4 4, page 4) three times.
➤ Use the "UP +" (Fig. 4 6, page 4) and "DOWN -" (Fig. 4 7,
page 4) buttons to select the battery monitor mode.
✓ The selected mode then appears in the display for a few sec-
onds. The display flashes several times before it returns to the
current temperature.
I
Note
When the cooler is supplied by the starter battery, select the battery
monitor mode "HIGH". If the cooler is connected to a supply battery,
the battery monitor mode "LOW" will suffice.
If you wish to operate the cooler from the AC mains, set the battery
monitor to the "LOW" position.
6.5

Using the cooler

a
Caution – Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the
heat that generated during operation can dissipate. Ensure that
the ventilation slots are not covered. Make sure that the device
is sufficiently far away from walls and other objects so that the
air can circulate.
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the
heated air can dissipate.
I Note
Place the cooler as shown (Fig. 1, page 3).If you operate the box
in a different position it can be damaged.
➤ Close the cooler, see "Connecting the cooler" on page 37.
I
Note
If you wish to operate the cooler from the AC mains, set the battery
monitor to the "LOW" position.
Operation
39