Hama EWS-165 Bedienungsanleitung Seite 6

• Select CH1 if you are only using the measuring station
supplied.
• The base station now shows the data measured (3) on the
selected measuring station (2).
6.3. Basic and manual settings
Automatic setting using the DCF signal
After the first time the base station is switched on and
successful transmission is established between the base
station and the measuring station, the clock will automatically
search for a DCF signal. During the search, the wireless
symbol (5) will flash.
Display
Display flashing
No display /
Displayed continuously
Displayed continuously
• If the station still does not receive a signal, press and
hold the ▲ button (16) for approx. 3 seconds to start the
manual search for the DCF signal. The wireless symbol (5)
will start to flash.
Note – Time settings
• The search process takes about 3-10 minutes. If the
search fails, it ends and is repeated at the next clock
hour.
• In the meantime you can, however, set the time and
the date manually.
• The clock automatically continues to search for the DCF
signal every hour. If the signal is received successfully,
the manually set time and date are overwritten. The
clock automatically continues to search for the DCF
signal every hour. If the signal is received successfully,
the manually set time and date are overwritten.
Searching for the DCF signal
Active
Inactive –
no signal reception
Successful –
signal is being received
• Press and hold the ▲ button (16) again for approx. 3
seconds to stop the manual search. The wireless symbol
(5) will go out.
Note – Summer time
• The clock automatically switches to summer time.
• Please note that DCF signal reception is required for
automatic summer time switch-over. If necessary, start
the DCF signal search manually.
Manually setting the date/time
Note – Time and time zone
• In press the MODE button (17) repeatedly to toggle
between the following different displays:
• Time with seconds display, time with weekday display,
time adjusted according to time zone with weekday
display, time adjusted according to time zone with
seconds display
• The time zone symbol (6) is displayed when the time
has been adjusted according to the time zone.
• Press and hold the MODE button (17) for approx. 3
seconds to make the following settings one after the other:
• Year (10)
• Month (13)
• Day (7)
• D/M – M/D (7/13) display
• 12/24 hour format (10)
• Hours (10)
• Minutes (10)
• Weekday (11)
• Time zone (10)
• Temperature unit (°C / °F) (11)
• To select the individual values, press the ▲ button (16) or
the  button (14) and confirm each selection by pressing
the MODE button (17).
• Press the MODE button (17) to adopt the set value
displayed and to skip.
• If you do not make an entry for 2 minutes, you
automatically exit the setup mode.
5