Startup / Operation - BOMANN DU 671 G Bedienungsanleitung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

• Turn the screws 4 x ST4*25 mm as far as these

stick out about 10 mm from the wall.

• Hang up the hood. Check the secure fitting, the

horizontal position and tighten first the upper and

then the lower screws through the hood body.

• Remove the protective foil from the ducts.

• Put on the outer (lower) duct and fix

it laterally to the hood with the

screws 2 x ST4*8.

For the extraction mode:

• Attach a flexible extraction hose (not

supplied) with an inner diameter of

Ø120 mm onto the connecting piece.

• Slide the inner (upper) duct along the

slide fixture into the outer (lower)

duct. Make sure that the inner duct is

aligned with the vents at the top.

• Determine the extension length of the duct cover

by pulling up the inner duct or sliding back into the

outer duct.

• Attach the mounting rail at the upper duct ending.

Drill mounting holes 2 x Ø8 mm and insert the

dowel pins. Use the screws 2 x ST4*25 mm to se-

cure the rail.

For the extraction mode:

• Check the correct position of the flexible extrac-

tion hose and connect it with the extraction out-

let to the outside.

• Pull the inner duct upwards and fasten the duct

cover laterally to the previously

mounted rail using the screws 2 x

ST4*10 mm.

Installing the activated carbon

Installing the activated carbon filter for recirculation

Installing the activated carbon

mode

• Remove the aluminum grease filter.

• Place the carbon filter onto the air intake of the

extraction duct. Make sure that the mounting pins

on the extraction duct engage the mounting slots

of the carbon filter. Turn the filter clockwise until it

clicks into place.

• Reinstall the aluminum grease filter.

Electrical connection

WARNING:

• The installation to the mains supply must conform

to the local standards and regulations.

• Improper connection may cause to an electric

shock

shock!

shock

• Do not modify the appliance plug. If the plug does

not fit properly to the outlet, let install a proper

outlet by an authorized specialist.

• The accessibility of the power plug must be en-

sured to disconnect the appliance from the power

supply in case of emergency.

• Ensure that your mains power corresponds with

the specifications of the appliance. The specifica-

tions are printed on the rating label.

• Connect the mains cable to a properly installed

and earthed wall outlet.

• If the plug after installation is not accessible, a

corresponding disconnect device must be availa-

ble to meet the relevant safety regulations.