Kenwood KDC-BT710DAB Bedienungsanleitung Seite 29

TROUBLESHOOTING
Symptom Remedy
"NO DEVICE" or • Switch off the developer options on the Android device.
"READING" keeps • Reconnect the Android device.
flashing. • If this does not solve the problem, the connected Android
device does not support [BROWSE MODE]. ( 27)
Playback is intermittent Turn off the power saving mode on the Android device.
or sound skips.
• Reconnect the Android device.
"ANDROID ERROR"/
• Restart the Android device.
"NA DEVICE"
No Bluetooth device is • Search from the Bluetooth device again.
• Reset the unit. ( 3)
detected.
Bluetooth pairing • Make sure you have entered the same PIN code to both
cannot be made. the unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again. ( 13)
• Adjust the microphone unit's position. ( 12)
Echo or noise is heard
during a phone • Check the [ECHO CANCEL] setting. ( 14)
conversation.
• Reduce the distance between the unit and the Bluetooth
Phone sound quality
is poor. device.
• Move the car to a place where you can get a better signal
reception.
Voice calling method is • Use voice calling method in a more quiet environment.
not successful. • Reduce the distance from the microphone when you
speak the name.
• Make sure the same voice as the registered voice tag is
used.
Symptom Remedy
Sound is being • Reduce the distance between the unit and the Bluetooth
interrupted or skipped audio player.
during playback of a • Turn off, then turn on the unit and try to connect again.
Bluetooth audio player. • Other Bluetooth devices might be trying to connect to the
unit.
The connected Bluetooth • Check whether the connected Bluetooth audio player
audio player cannot be supports Audio/Video Remote Control Profile (AVRCP).
controlled. (Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
"DEVICE FULL" The number of registered devices has reached its limit.
Retry after deleting an unnecessary device.
( 16, DEVICE DELETE)
"N/A VOICE TAG" Make sure the same voice as the registered voice tag is
used.
"NOT SUPPORT" The connected phone does not support Voice Recognition
feature or phonebook transfer.
"NO ENTRY"/"NO PAIR" There is no registered device connected/found via
Bluetooth.
"ERROR" Try the operation again. If "ERROR" appears again, check if
the device supports the function you have tried.
"NO INFO"/"NO DATA" Bluetooth device cannot get the contact information.
"HF ERROR XX"/ Reset the unit and try the operation again. If this does not
"BT ERROR" solve the problem, consult your nearest service center.
25
ENGLISH