Kenwood KDC-BT710DAB Bedienungsanleitung Seite 18

BLUETOOTH®
The following operations may differ or not available depending on the
connected phone.
To
First incoming call...
Answer a call
Reject a call
End a call
While talking on the first incoming call...
Answer another
incoming call and hold
the current call
Reject another incoming
call
While having two active calls...
End current call and
activate held call
Swap between the
current call and held call
Adjust the phone volume
[00] to [35] (Default: [15])
Switch between hands-free
and private talk modes
14
ENGLISH
On the faceplate
Press or the volume knob or one of
the number buttons (1 to 6).
Press .
Press .
Press .
Press .
Press .
Press .
Turn the volume knob during a call.
• This adjustment will not affect the
volume of the other sources.
Press during a call.
• Operations may vary according to the
connected Bluetooth device.
Improve the voice quality
While talking on the phone...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table),
then press the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
MIC GAIN LEVEL –10 to LEVEL +10 (LEVEL –4): The sensitivity of the
microphone increases as the number increased.
NR LEVEL LEVEL –5 to LEVEL +5 (LEVEL 0): Adjust the noise reduction level until
the least noise is being heard during a phone conversation.
ECHO CANCEL LEVEL –5 to LEVEL +5 (LEVEL 0): Adjust the echo cancellation delay
time until the least echo is being heard during a phone conversation.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select an item (see the following table),
then press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press and hold to exit.
To return to the previous setting item, press
SETTINGS
AUTO ANSWER 1 to 30: The unit answers incoming call automatically in the selected time
(in seconds). ; OFF: Cancels.
BATT/SIGNAL* AUTO: Shows the strength of the battery and signal when the unit detects
a Bluetooth device and the Bluetooth device is connected. ;
OFF: Cancels. Clock time is shown.
* Functionality depends on the type of the phone used.
.
Default: XX
.
Default: XX