Cameo CLPST64RGBAQ8W Bedienungsanleitung Seite 13

MODE SELECTION / MODUS AUSWÄHLEN / SÉLECTION DE MODE / SELECCIÓN DEL MODO / WY-
BÓR TRYBU / SELEZIONE DELLE MODALITÀ
EN NOTE
When the projector is properly connected to the mains, the following information appears successively in the display during the startup process:
"Software Update, Please Wait..." (for service purposes only), the software version "Software V1.xx" and "WELCOME TO cameo". After this operation,
the projector is ready for use and changes back to the mode that was previously selected.
STATIC COLOUR
Press the MODE button repeatedly if necessary to select the Static Colour Mode (CXXX), then press the ENTER button (2. digit blinks) to choose one
of the static colours or the strobe function by using the UP and DOWN buttons. C1 represents Red, C2 = Green, C3 = Blue, C4 = Amber and CF =
Strobe.
Press ENTER again (3. and 4. digit blink) to adjust the brightness of the pre-selected colour (CX00 - CX99) and the strobe speed (CF00 - CF99) by
using the UP and DOWN buttons. Press ENTER to confirm.
Examples: If you set C1, C2, C3 and C4 to zero, the Quad Par Can will have no LEDs on (blackout).
If you set C1 to 99 and C2, C3 and C4 to zero, the colour will be 100% Red.
RED
Brightness C100 - C199
GREEN
Brightness C200 - C299
COLOUR MACRO MODE (15 COLOURS)
Press the MODE button (repeatedly, if necessary) to select the "Colour Macro" mode (CMXX). Confirm with ENTER and then use the UP and DOWN
buttons to select the desired colour. Confirm with ENTER.
1. Red
2. Green
3. Blue
4. Amber
5. Yellow
6. Cyan
7. Lavender
8. Pink
9. Bright Green
10. Magenta
11. Turquoise
12. orange
13. Bright Magenta,
14. warm white
15. cold White
BLUE
Brightness C300 - C399
AMBER
Brightness C400 - C499
STROBE
Speed CF00 - CF99
13