Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning The Appliance; Eliminating Minor Faults Yourself - Siemens KD7...N Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Cleaning the
appliance
1. Attention: Pull out the mains plug or
switch off the fuse!
2. Wipe the door seal with water only and
then dry thoroughly.
3. Clean the appliance with tepid rinsing
water. The rinsing water must not drip
onto the fascia or light.
4. After cleaning: reconnect and switch on
the appliance.

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following information.
Customer service will charge you for advice, even if the appliance is still under guarantee!
Fault
A fault code (e. g.
indicated on the display.
Interior light does not
function;
the refrigerating unit is
running.
The temperature
in the refrigerator
compartment is too
cold.
Refrigerator has no
cooling capacity.
Possible cause
) is
The appliance has detected a fault
E01
during an automatic self-test.
The bulb is defective.
Temperature has been set too
low.
If large quantities of fresh food
are being frozen, the
temperature in the refrigerator
compartment drops temporarily,
as the refrigerating unit runs for a
long time.
Power failure; the fuse has been
switched off; the mains plug has
not been inserted properly.
t~êåáåÖW
kÉîÉê=ìëÉ=~=ëíÉ~ã=ÅäÉ~åÉê=íç=ÅäÉ~å=íÜÉ=
~ééäá~åÅÉK=píÉ~ã=ã~ó=ÅçãÉ=áåíç=Åçåí~Åí=
ïáíÜ=ÉäÉÅíêáÅ~ä=ÅçãéçåÉåíë=~åÇ=Å~ìëÉ=
~ ëÜçêíJÅáêÅìáí=çê=~å=ÉäÉÅíêáÅ=ëÜçÅâ>=
qÜÉ ëíÉ~ã=ã~ó=Ç~ã~ÖÉ=íÜÉ=éä~ëíáÅ=
ëìêÑ~ÅÉëK
aç=åçí=ìëÉ=~Äê~ëáîÉ=çê=~ÅáÇáÅ=ÅäÉ~åáåÖ=~ÖÉåíë=
~åÇ=ëçäîÉåíëK
qÜÉ=êáåëáåÖ=ï~íÉê=ãìëí=åçí=êìå=áåíç=íÜÉ=
îÉåíáä~íáçå=çéÉåáåÖ=çå=íÜÉ=ÇççêK
kÉîÉê=ÅäÉ~å=íÜÉ=ëÜÉäîÉë=çê=Åçåí~áåÉêë=áå=íÜÉ=
ÇáëÜï~ëÜÉêK=qÜÉ=é~êíë=ã~ó=ï~êé>
Remedial action
Call customer service and
report the fault code.
Replace bulb.
1. Pull out the mains plug or
disconnect the fuse.
2. Change the bulb
(Replacement bulb, 220-240V
a.c., E14 bulb holder, see
defective bulb for wattage).
Increase the temperature.
Do not exceed max. freezing
capacity.
Check whether the power is
on, check the fuses.
en
25

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis