Damage To The Product; Manufacturer's Address; Technical Terms - Homa C80 Betriebsanleitung

1.5.2. Spare parts, add-ons and conversions
Only original spare parts as supplied by the manufacturer may be used for repairs, replacements, add-ons and
conversions. Only these parts guarantee a long working life and the highest level of safety. These parts have
been specially designed for our products. Self-made add-ons and conversions or the use of non-original spare
parts can seriously damage the product and/or injure personnel.
1.5.3. Maintenance
The prescribed maintenance and inspection work should be carried out regularly. This work may only be carried
out by qualified, trained and authorized personnel. The maintenance and inspection log supplied must be
properly updated. This enables you to monitor the status of inspections and maintenance work. Quick repairs
not listed in this operation and maintenance manual and all types of repair work may only be performed by the
manufacturer and its authorized service centres.

1.5.4. Damage to the product

Damage as well as malfunctions that endanger safety must be eliminated immediately by authorized personnel.
The product should only be operated if it is in proper working order. During the agreed warranty period, the
product may only be repaired by the manufacturer or an authorized service workshop! The manufacturer reserves
the right to recall the damaged product to the factory for inspection!
1.5.5. Exclusion from liability
No liability will be assumed for product damage if one or more of the following points apply:
• Incorrect design on our part due to faulty and/or incorrect information provided by the operator or customer
• Non-compliance with the safety instructions, the regulations and the requirements set forth by German law and
this operating and maintenance manual
• Incorrect storage and transport
• Improper assembly/dismantling
• Improper maintenance
• Unqualified repairs
• Faulty construction site and/or construction work
• Chemical, electrochemical and electrical influences
• Wear
In case of a power failure or another technical failure, by which a proper operation of the pump is no longer
guaranteed, it is essential to take care that damages by an overflow of the pump sump are prevented securely, for
example, by installing a mains-independent alarm or other appropriate protective measures.
This means the manufacturer's liability excludes all liability for personal, material or financial injury.

1.5.6. Manufacturer's address

HOMA Pumpenfabrik GmbH
Industriestrasse 1
D-53819 Neunkirchen-Seelscheid
Phone: +49 2247 / 7020
Fax: +49 2247 / 70244
Email: info@homa-pumpen.de
Homepage: www.homapumpen.de

1.6. Technical terms

Various technical terms are used in this operating and maintenance manual.
Dry run
The product is running at full speed, however, there is no liquid to be pumped. A dry run is to be strictly avoided. If
necessary, a safety device must be installed.
"wet" installation type
This installation type requires the product to be immersed in the pumped fluid. It is completely surrounded by the
pumped fluid. Please observe the values for the maximum submersion depth and the minimum water coverage.
"dry" installation type
In this installation type, the product is installed dry, i.e. the pumped fluid is delivered to and discharged via a
pipeline system. The product is not immersed in the pumped fluid. Please note that the surfaces of the product
become very hot!
"transportable" installation type
With this installation type the product is equipped with a pedestal. It can be installed and operated at any location.
Please observe the values for the maximum submersion depth and the minimum water coverage, and remember
that the surfaces of the product become very hot.
23