Danger To Life - EuroLite LED MFX-5 Bedienungsanleitung

The fixture's base enables to be mounted in two ways.
The Moving-Head can be placed directly on the stage floor or rigged in any orientation on a truss without
altering its operation characteristics (see the drawing).
For overhead use (mounting height >100 cm), always install an appropriate safety bond.
You must only use safety bonds and quick links complying with DIN 56927, shackles complying with DIN EN
1677-1 and BGV C1 carbines. The safety bonds, quick links, shackles and the carbines must be sufficiently
dimensioned and used correctly in accordance with the latest industrial safety regulations (e. g. BGV C1,
BGI 810-3).
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Install the safety bond by inserting the quick link of the safety bond through the attachment eyelet on the
bottom of the device. Pull the safety bond over the trussing system or a safe fixation spot. Insert the end in
the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!

DANGER TO LIFE!

26/36
Screw one clamp each via a
M10 screw and self-locking nut
onto the Omega-holder.
Insert the quick-lock fasteners
of the first Omega-clamp into
the respective holes on the
bottom of the device. Tighten
the quick-lock fasteners fully
clockwise. Install the second
Omega-clamp.
(1) Omega-holders
(2) Clamp
(3) Safety-rope
(4) Quick-lock fastener
00100136.DOC, Version 1.0