Battery Charge; Changing The Display Language - Panasonic KX-TCA130FX Bedienungsanleitung

TCA130FX(EX).book Page 6 Wednesday, April 20, 2005 3:10 PM
• Only use the included base unit (or charger) to charge the battery(ies). Do
not tamper with the base unit (or charger). Failure to follow these
instructions may cause the battery(ies) to swell or explode.
Connections
• The AC adaptor must remain connected at all times. (It is normal for the
adaptor to feel warm during use.)

Battery charge

Place the handset on the charger for about 7 hours before initial use.
Note:
• The handset display may show "Please Wait..." when the handset is
placed on the charger if it is not registered to a base unit.

Changing the display language

16 display languages are available. You can select "Deutsch",
"English", "Magyar", "Polski", "slovensky", "ČeŠtina",
"Hrvatski", "Slovenscina", "Eesti", "LIETUVIŠKAI",
"LatvieŠu", "Românã", "БЪЛГАРСКИ", "Srpski", "МАКЕДОНСКИ", or
"Shqiptar".
1
Press $ (middle soft key).
2
Select Y, then press ,.
3
Select "Display Setup", then press ,.
4
Select "Select Language", then press ,.
5
Select the desired language, then press ,.
6
Press {ih}.
Note:
• If you select a language you cannot read, press {ih}, $, press {v},
press ,, press {v} 2 times, press ,, press {v} 3 times, press
,, select the desired language, then press ,. Press {ih}.
Registering the handset to KX-TCD300/KX-TCD320/
KX-TCD340 base unit
Ensure that the handset is switched on. If it is not on, press and hold {ih}
for few seconds to turn the handset on.
6