Battery Charge; Changing The Display Language - Panasonic KX-TCA181FX Bedienungsanleitung

TCA181FX(EX).book Page 7 Tuesday, September 13, 2005 9:36 AM

Battery charge

Place the handset on the charger for about 7 hours before initial use.
Note:
• The handset display may show "Please Wait..." when the handset is
placed on the charger if it is not registered to a base unit.

Changing the display language

16 display languages are available. You can select "Deutsch",
"English", "Magyar", "Polski", "slovensky", "ČeŠtina",
"Hrvatski", "Slovenscina", "Eesti", "LIETUVIŠKAI",
"LatvieŠu", "Românã", "БЪЛГАРСКИ", "Srpski", "МАКЕДОНСКИ", or
"Shqiptar".
1
{ih} i " i m i #
2
Push the joystick down 3 times. i #
3
Push the joystick down 3 times. i #
4
Select the desired language. i # i {ih}
Registering the handset to KX-TCD810/KX-TCD820
base unit
Ensure that the handset is switched on. If it is not on, press and hold {ih}
for few seconds to turn the handset on.
1
Lift the handset and press {ih} to put the handset in standby mode.
2
Press and hold {x} on the base unit for about 3 seconds, until the
registration tone sounds.
3
Place the handset on the base unit. The registration tone continues to
sound. With the handset still on the base unit, wait until a confirmation
tone sounds and w stops flashing.
Note:
• If an error tone sounds, or if w is still flashing, register the handset
manually. (See manual registration in the KX-TCD810/KX-TCD820
operating instructions.)
• If all registered handsets start ringing in step 2, press {x} to stop. Start
again from step 1.
• Charge the batteries for about 7 hours before initial use.
7