Timer Mode; Manual Mode; Continuous Fogging; Controlling Several Devices Via One Remote-Control - EuroLite NX-150 Bedienungsanleitung

LCD-display
MU
01-99 (minutes)
SE

Timer mode

01-99 (seconds)
VO
01 minimum - 10 maximum
DE

Manual mode

01-99 (seconds)
HEAT
Heating
flashing = heating phase
phase
Ok = ready
Timer mode
By pressing the Timer-button, the device works with the adjusted settings (MU, SE and VO). The green LED
below the Timer-button shows that the Timer-function is activated. If you wish to deactivate the Timer-
function, press the Timer-button again.
Manual mode
By pressing the Manual-button, the fog emission is immediately triggered with the duration adjusted under
"DE". The Manual-mode is automaticall stopped after the duration you defined or by pressing the Manual-
button again.

Continuous fogging

By pressing the Continuous-button, the device produces continued fog. The continued fog is only interrupted
by necessary heating pauses. The green LED below the Continuous-button shows that the Continuous-
function is activated. If you wish to deactivate the Continuous-function, press the Continuous-button again.
CAUTION: The escape nozzle will heat up during operation. Therefore do not touch the nozzle until it
has cooled down completely.

Controlling several devices via one remote-control

You can control several NX-150 with one remote-control. If two or more device are connected, they will work
similarly.
Only use a stereo shielded cable and 5-pin XLR-plugs and connectors in order to connect one device with
another.
Connect the Remote Control with the Remote Control-input of the first device. Connect the Remote Control-
output of the first device with the Remote Control-input of the next device. Always connect one output with
the input of the next device until all devices are connected.
DMX-512 control
The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
the devices will not work at all, or will not work properly.
Function
Adjust the interval between each fog emission
Adjust the duration of each fog emission
Adjust the output volume
Adjust the duration of each fog emission
Display of heating phase
21/46 00020505.DOC, Version 1.1