Operation Via Cable Remote Conrol; Manual Fog Output; Continuous Mode; Timer Mode - EuroLite N-150 MK2 Bedienungsanleitung

Operating conditions
The output nozzle will heat up during operation. Therefore do not touch the nozzle until it has cooled
down completely!
Prior to transportation, allow the machine to cool down and completely empty the tank.
Never operate the fog machine without fog fluid. Fire hazard due to overheating! Besides, the unit may
be damaged.
During operation smoke emission may stop. In this case the device is heating up again. After a short
period, the machine will be ready to emit fog again. This process guarantees an appropriate
vaporization temperature and the best fog emission possible. The temperature is regulated by a high-
quality thermostat.
Notes
• All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so after
being turned off.
• All fog machines have a recycling period after long bursts when the machine will shut itself down for a short
period in order to heat up again. During this time no fog can be produced.
• If you experience low output, pump noise or no output at all, disconnect from mains immediately. Check the fluid
level, the external fuse, remote control connection and the power supply. If all of the above appears to be ok,
reconnect the unit again. If fog does not come out after holding the remote control button on the remote control
for 30 seconds, check the tube attached to the tank to make sure there is fluid going through it. If you are unable
to determine the cause of the problem, do not simply continue pushing the remote button, as this may damage
the unit. Return the machine to your dealer.
Connect the included cable remote control to the REMOTE CONTROL jack. The remote allows
operating the machine in three modes (manual mode, continuous mode and timer mode). In all
three modes, the OUTPUT control can be used to adjust the fog output volume between 0 and
100 %.

Manual fog output

To manually activate a fog output, press the green MANUAL button on the remote control. While
this button is kept pressed, the unit will emit the maximum amount of fog. Use the OUTPUT control
to adjust the output volume.
The manual mode will take priority over the continuous and timer mode, i.e. when the green button
is pressed, the unit will always emit the maximum amount of fog even if one of the other modes is
activated.

Continuous mode

In the continuous mode, the fog machine will emit fog continuously. To activate the continuous
mode, press the red CONTINOUS button, so that it will engage and the control indicator above the
button lights up. Use the OUTPUT control to adjust the output volume. To deactivate the
continuous mode, disengage the red CONTINOUS button again. The red control indicator above it
will be extinguished.
The continuous mode will take priority over the timer mode, i.e. when the red button is pressed;
the unit is set to continuous mode even if the timer mode is activated with the button timer.

Timer mode

In the timer mode, the fog machine will automatically emit fog. The time intervals, duration and fog
volume are adjustable. To activate the timer mode, press the yellow TIMER button so that it will
engage and the control indicator above the button lights up. With the control INTERVAL, adjust
the intervals between the individual fog outputs between 0 and 30 minutes. With the control
DURATION, adjust the duration of the fog outputs between 0 and 15 seconds. Use the OUTPUT
control to adjust the output volume. To deactivate the timer mode, disengage the yellow TIMER
button again. The yellow control indicator above it will be extinguished.

OPERATION VIA CABLE REMOTE CONROL

CAUTION!
19 • EN