Timer Mode; Notes Regarding Operation - EuroLite dynamic faze 700 Bedienungsanleitung

Timer Mode

In the timer mode, the fog machine will automatically emit fog. The time intervals, duration and
fog volume are adjustable.
1
To activate the timer mode, press the yellow button TIMER so that it will engage and the
control indicator above the button starts flashing.
2
With the control INTERVAL, adjust the intervals between the individual fog outputs
between 0 and 30 minutes.
3
With the control DURATION, adjust the duration of the fog outputs between 1 and 15
seconds.
4
With the control OUTPUT, adjust the fog output volume between 0 and 100 %.
5
To deactivate the timer mode, disengage the yellow button TIMER again. The yellow
control indicator above it will be extinguished.

Notes Regarding Operation

1
All fog machines develop condensation around the output nozzle. Because this may result in some
moisture accumulation on the surface below the output nozzle, consider this condensation when
installing your unit.
2
All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so
after being turned off.
3
All fog machines have a recycling period after long bursts when the machine will shut itself down for a
short period in order to heat up again. During this time no fog can be produced.
4
If you experience low output, pump noise or no output at all, disconnect from mains immediately. Check
the fluid level, the external fuse, remote control connection and the power supply. If all of the above
appears to be ok, reconnect the unit again. If fog does not come out after holding the MANUAL button
on the remote control for 30 seconds (make sure the fog output volume is adjusted with the control
OUTPUT), check the tube attached to the tank to make sure there is fluid going through it. If you are
unable to determine the cause of the problem, do not simply continue pushing the remote button, as
this may damage the unit. Return the machine to your dealer.
www.eurolite.de
19