Schulthess Spirit eMotion 7020 Bedienungsanleitung Seite 46

5.
Connect the hose again.
6.
Unscrew the hose only from the back of the machine.
7.
Pull out filter using a pair of flat-nose pliers. Clean and
reinsert it.
8.
Connect the hose again.
9.
Turn the water tap on and make sure that no water
escapes.
10.
Turn the water tap off.
On machines with AquaStop
3.
Switch off the mains power supply
4.
Unscrew the hose only from the water tap.
5.
Pull out filter using a pair of flat-nose pliers. Clean and
reinsert it.
6.
Connect the hose again.
7.
Turn the water tap on and make sure that no water
escapes.
8.
Turn the water tap off.
46
Problems
Repairs, alterations or intervention on electronic equip-
ment should only be carried out by qualified specialists.
Inexpert repairs can cause considerable damage and risk
to the user.
Only original spare parts should be used for repairs.
Please find below minor faults which you can rectify
yourself.
Error messages on the display
If the following error messages are displayed, the pro-
gramme can be restarted by pressing the start button
once the error has been rectified.
«CHILD LOCK ACTIVE»
Hold the «Quick wash» button down and press the
start button.
«PLEASE CLOSE DOOR»
Push the door closed until the lock catches properly.
The selected programme starts automatically.
«CHECK WATER SUPPLY»
Turn on the tap and start again.
Filter in water supply is blocked: Clean the filter, see
chapter «Cleaning and Maintenance / Cleaning the filter
in the water inlet».
«CHECK DRAIN»
Check whether the drainage hose is blocked.
Foreign bodies block the drain pump: clean pump
according to chapter «Cleaning and Maintenance/
Emergency emptying».
The water drain provided by the customer is blocked:
Carry out an emergency discharge according to chapter
«Cleaning and Maintenance» and clean the drain siphon
(built-in siphon).
The position of the drain hose is too high.
The maximum pumping height is 1m above ground.
«UNBALANCE NO SPINNING»
Excessive imbalance. Laundry not spun.
Press the Start button and then the «Quick wash»
button to end the wash programme.
Open the door and redistribute the load.
Repeat the spin cycle with the separate spin
programme.
General information:
Avoid loading the drum with one single heavy
item.Wash large and small laundry together.
«FOAM, PROG. EXTEND»
The washing machine has detected foam and taken
adequate measures. The spinning cycle of the laundry
could be completed.
In future, please reduce the detergent quantity.
«FOAM, PROG.CANCEL»
Due to extremely intensive foaming, the washing
machine could not complete the spinning cycle and the
wash programme had to be aborted.
Repeat the wash programme without adding any
detergent.
In future, please reduce the detergent quantity
(if required use washing powder instead of liquid deter-
gent).