Water supply hose
Only for machines without Aquastop. To avoid water
damage, we recommend having this checked by a
specialist after around 5 years of fault-free operation.
Frost protection
If the machine is in a room susceptible to frost, all residual
water must be removed from the detergent pump and
water supply and drain hoses immediately after use.
Emptying the drain pump
See chapter «Emergency emptying».
Emptying the water supply hose
Turn off the water supply
On machines without Aqua-Stop
Screw off the hose at the tap, let the water run into a
bowl.
Screw the hose back onto the tap.
On machines with Aqua-Stop
Screw off the hose at the tap, place it in a bowl, switch
on any optional wash programme and terminate after
approx. 40 seconds using the Quick Wash button.
The residual water will flow out from the water inflow
hose, let the water run into the bowl.
Screw the hose back onto the tap.
Cleaning the detergent drawer
1.
Pull the detergent drawer out until it stops.
2.
Press down in the middle of the softener chamber cover,
and pull the drawer all the way out.
3.
Remove the divider.
50
4.
Clean the chambers and insert under running water.
5.
Replace the divider in the detergent drawer.
6.
Replace the drawer in the machine.