Using The Device For The First Time; Inserting The Batteries; Setting The Date And Time; Manual Setting - Microlife aponorm Professionell Gebrauchsanweisung

3. Using the Device for the First Time

Inserting the batteries

After you have unpacked your device, first insert the batteries.
The battery compartment is on the bottom of the device.
5
Insert the batteries (4 x size AAA 1,5 V), thereby observing
the indicated polarity. Switch the Lock Switch
position.

Setting the date and time

Your aponorm
® Professionell upper arm blood pressure monitor
is equipped with a radio clock, which is controlled by the DCF77
signal. This time and date are set automatically. If no DCF77 sig-
nal (this is the term for the time signal transmitter) is available,
the time is not adjusted automatically.
The display comes to receiving mode and device sets the time
automatically, after insert batteries.

If you do not wish to set the time or you want to take a
measurement immediately, exit the time setting mode by
pressing the Start/Stop button
Once the time signal is received, the radio clock icon
on the display every second until the reception of the DCF77
signal is complete.
While receiving the DCF77 signal, the radio clock icon
first with 1, then 2 and then 3 bars above it. When the icon
appears with 3 bars, the time has been set. First the date and
then the time are displayed at the top right of the display. Then
the time is displayed permanently together with the radio clock
icon .
30

The automatic setting of date and time takes about 2-4
minutes. If no signal is received within 10 minutes, „-: - -"
appears on the display.
18
Now you need to improve the reception by choosing another
location or set the clock manually (for more information see
„manual setting"). After a change of location, batteries have to
be re-inserted or to reset radio clock to „ON" to restart the auto
setting again.

Manual setting

to «unlock»
14
(if automatic setting does not work or is not desired):
The device must be in ON mode. If you do not press any
buttons for 1 minute during the time setting, the time setting
mode switches off and „ - : - - " appears in the clock display.
1. Press down Time button several seconds until „bI OFF "
2. Press Time button again, the radio clock indicator and
3. Press the M button to switch on („ON") or switch off the
4. Press ON/OFF button to confirm and return to standby mode,
.
1
1. The year number flashes in the display. You can set the year
flashes
30
2. Press the «+»
flashes
30
3. Follow the instructions above to set the day, hour and
4. Once you have set the minutes and pressed the time button,
5. If you want to change the date and time, press and hold the
appears on the display.
„ON" appears in the display.
radio clock („OFF").
or if the radio clock is switched off, you can press Time
button to confirm (continue with step 1).
by pressing either the «+» or the «-»
13
and then set the month, press the time button
or the «-» button to set the month. Press
13 12
the time button to confirm and then set the day.
10
minutes.
the date and time are set and the time is displayed.
time button down for approx. 3 seconds until the year
number starts to flash. Now you can enter the new values
as described above.
button. To confirm
12
.
10
aponorm
® by