The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
OPERATION
After you connected the effect to the mains, the LED Techno Strobe 250 starts running.
On the rear panel ot the LED Techno Strobe 250 there is a rotary control to adjust the flash-rate (1-10
flashes per second). Also you will find a rotary control to adjust the sound sensitivity.
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
Flash-rate:
Maximum ambient temperature T
Maximum housing temperature T
Min. distance from flammable surfaces:
Min. distance to lighted object:
Number of LEDs:
Dimensions (LxWxH):
Weight:
Please note: Every information is subject to change without prior notice. 06.05.2009 ©
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
:
a
(steady state): 45° C
C
230 V AC, 50 Hz ~
max. 5 W
1-10 Hz
45° C
0.5 m
0.1 m
74
170 x 175 x 175 mm
0.5 kg
12/12
00046335.DOC, Version 1.0