Makita DTD136 Betriebsanleitung Seite 8

Changing the impact force (Fig. 8)
Impact force grade
displayed on panel
Hard
Medium
Soft
T mode
013975
The impact force can be changed in four steps: hard,
medium, soft, and T mode.
This allows a tightening suitable to the work.
Every time the button
changes in four steps.
"T" is a special mode for fastening self drilling screws. In
this mode, the tool starts to drive a screw with faster rota-
tion, which is suited for drilling with the self-drilling-screw
tip. Once the tool starts to tighten the screw, it impacts in
medium force grade.
For approximately one minute after releasing the switch
trigger, the impact force can be changed.
NOTE:
• When all lamps on the switch panel go out, the tool is
turned off to save the battery power. The impact force
grade can be checked by pulling the switch trigger to
the extent that the tool does not operate.
• While pulling the switch trigger, the impact force grade
cannot be changed.
Indicating the remaining battery capacity (Fig. 9)
(Country specific)
When you pull the switch trigger, the LED display shows
the remaining battery capacity.
The remaining battery capacity is shown as the following
table.
8
Maximum blows
DTD136 DTD147
3,200 3,400
–1 –1
(min ) (min
2,600 2,800
–1 –1
(min ) (min
1,100 1,300
–1 –1
(min ) (min
2,600 2,800
–1 –1
(min ) (min
is pressed, the number of blows
Application
Tightening when force and
) speed are desired.
Tightening when a good
) finishing is needed.
Tightening when excessive
tightening need to be avoided
because of potentially
) clogged female screw and
broken or damaged screw
head.
Tightening when speed and
) good finishing are needed.
LED indicator status
012273
NOTE:
• When the LED display goes off, the tool is turned off to
save the battery power. To check the remaining battery
capacity, slightly pull the switch trigger.
• The LED display goes off approximately one minute
after releasing the switch trigger.
• When the tool is overheated, the light flashes once per
second for one minute, and then the LED display goes
off. In this case, cool down the tool before operating
again.
• When the LED display lights up and the tool stops even
with a recharged battery cartridge, cool down the tool
fully. If the status will not change, stop using and have
the tool repaired by a Makita local service center.
Work
Tightening in underwork
material/Tightening long
screws/Tightening bolts.
Tightening in the finishing
board, plaster board.
Tightening sash screw/
Tightening small screws such
as M6.
Tightening self drilling screws.
Remaining battery capacity
About 50% or more
About 20% – 50%
About less than 20%