Emptying The Waste Containers; Cleaning - UNITED OFFICE CROSS CUT SHREDDERUAV 250 A1 Bedienungsanleitung

Clearing a material blockage:
u
• Move the switch
position if the material being shredded causes
a blockage.
The appliance now goes into reverse and the
material that is being shredded is ejected.
u
• Move the switch
soon as the jammed material has been ejected.
Switching the appliance off:
• Switch the appliance off by moving the switch
to the "OFF" position.

Emptying the waste containers

• Empty the waste containers
• Empty the large waste container
when paper is visible in the viewing window
• Dispose of the waste material in an environmen-
tally responsible manner.
Emptying the large waste container
Caution:
Remove the power plug from the wall socket to avoid
unintentional starting of the appliance
• Remove the cutter attachment
r
waste container
• Pull the small waste container
the large waste container
• Empty the large waste container
assemble the components.
to the "REV" ("reverse")
to the "OFF" position as
w r
/ regularly.
r
at the latest
q
from the large
.
w
upwards out of
r
on the guide rails.
r
and then re-
Emptying the small waste container
• Remove the cutter attachment
waste container
• Pull the small waste container
the large waste container
so that you can empty it.
• Empty the small waste container
reassemble the components.

Cleaning

u
Danger!
Always remove the power plug before cleaning the
appliance. There is a risk of receiving an electric
shock!
Warning!
e
. The cutters in the appliance are very sharp! Injury
hazard!
Attention:
Do not spray any oil or other lubricants into the cut-
t
ter openings
ge the appliance!
• Remove any residue left in the cutting openings
t y
/ or cutting blades with a suitable tool, e.g.
a pair of tweezers. Ensure that the plug has been
disconnected.
• Clean the appliance with a lightly moistened
cloth. For stubborn soiling use a mild detergent
on the cloth.
- 5 -
q
from the large
r
.
w
upwards out of
r
on the guide rails
w
y
/ . These would irreparably dama-
and then