Velleman CAMIP18 Bedienungsanleitung Seite 7

choose "Port Forwarding".
3.
Enter the camera IP address and port number that you noted down and enable this rule. You can
now access your camera through the internet.
4. If your wireless router supports UPnP (Universal Plug and Play), make sure the function is enabled.
UPnP enhances communication between the router and wireless devices. If necessary, refer to the
manual of the router software.
Checking the Connection
When you have completed network setup and port forwarding, check your connection setup as follows:
1.
On your mobile device, switch your network mode to 3G or connect to a different wireless network
than the one that has your camera connected.
2. Start EagleEyes and select the camera you just added to see if you can access it.
If yes, your network connection works. Proceed with "Changing the Account User Name and
o
Password" below.
o If not, proceed with the following step.
3.
Switch your network mode back to the wireless network that has your camera connected.
4. Start EagleEyes, and add a new connection with the IP address and port number that you set up in
"Adding Your Camera to the EagleEyes App".
5. See if you can access the camera with this connection.
o If yes, return to "Port Forwarding" to set up port forwarding again.
o If not, return to step 4 of "Adding Your Camera to the EagleEyes App" and reconfigure the
connection.
Changing the Account User Name and Password in EagleEyes
To ensure the safety of your camera connection, modify the default user name and password as follows:
1. On your mobile device, access the camera in EagleEyes.
2.
Press the Configuration button
3. Select Advance Setup > Account.
4.
Modify the default user name (admin) and password (admin) to the ones you prefer.
8. EagleEyes Operation
Address Book
V. 01 – 14/02/2014
CAMIP18
.
Live View & Control Configuration
7 ©Velleman nv