Velleman CAMIP18 Bedienungsanleitung Seite 3

o wall plugs
o cap
o M6 nylok screws
o spirit level
o M4 screw
o mounting base screw
•
Power drill
1. Attach the mounting base to the speed dome camera.
•
Put the cables (depending on your configuration, power supply and/or 8P8C network cables) through
the hole of the camera-mounting base.
•
Align the breach of the base to the arrow mark on the speed dome camera, and use two M6 Nylok
screws to attach the base to the speed dome camera.
•
To make the bracket installation easier, fasten the two mounting base screws to the location as
shown below.
•
Note: The screws are longer than the screw holes. Just fasten the screws until they're fixed.
2.
Attach the bracket to the wall.
•
The bracket is composed of two parts: the upper part and the bottom part. Remove the upper part
by loosening the screw on it. Use the four mounting screws and wall plugs to attach the bottom part
to the wall, as shown below.
•
Use the spirit level supplied with the bracket package to check the surface is horizontal or not. If the
surface is horizontal, the bubble will remain in the centre circle of the spirit level.
3. Attach the speed dome camera to the bracket.
•
Put the cables through the hole of the bracket.
•
Attach the camera to the bracket with the two mounting base screws going through, and rotate the
bracket as indicated below. The camera will be hooked on the bracket.
•
Slightly secure the camera and the bracket with three M6 Nylok screws.
V. 01 – 14/02/2014
CAMIP18
3 ©Velleman nv