Initial Operation; Installing The Handle Bar; Install/Empty Grass Catchment Basket - Grizzly BRM 56-163 BSA Quattro Originalbetriebsanleitung

UK
• Disconnect the charger from the
mains before closing or opening con-
nection to the battery / power tool /
device. This ensures that the battery
and charger are not damaged.
• Keep the charger clean and away
from wet and rain. Do not use the
charger outdoors. Dirt and the entry
of water increase the risk of electric
shock.
• Operate the charger only with the ap-
propriate original batteries. Charging
other batteries may result in injuries
and risk of fire
• Avoid mechanical damage to the
charger. This can result in internal
short circuits.
• Do not operate the charger on a com-
bustible surface (e.g. paper, textiles).
Risk of fire due to heating during char-
ging.
• If the power cable for this equipment
is damaged, it must be replaced by
the manufacturer, a customer ser-
vice agent of the same or a similarly
qualified person in order to prevent
hazards.

Initial Operation

Caution! Risk of injury from
rotating blades. Carry out work
on the equipment only when the
blade is switched off and sta-
tionary.
Observe the Briggs & Stratton in-
struction manual supplied.
Before starting the equipment, you must
- Remove the Protective Caps
- Install the handle bar
- Install the grass collection box
- Charge the battery
96
- Fill with engine oil
- Fill with petrol
- adjust cutting height if required

Installing the Handle Bar

Caution! When installing
the handle bar, ensure that
the Bowden cables are not
squashed.
1. There is a drill hole located on
the lower end of the handle bar
which is tightened using the cor-
responding bolts in the holder
on the device. This creates the
lower pivot point used to adjust
the tilt angle.
2. Fasten the lower handle bar (4)
using the bar fastening screws
and wing nuts.
You can determine the desired
tilt by selecting one of the two
possible screw positions.
3. Unfold upper handlebar (1)
and push locking lever (20)
D
toward bar.
4. Fix the Bowden cables to the
bar using the cable clamp (5)
Install/empty grass catchment
basket
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Assemble grass catchment
basket (19):
1. Pull plastic loops (28) over bas-
ket rods (27).