Water Outlet; Removing The Water Collecting Container; Continuous Or Extended Operation - ATIKA ALE 600 Betriebsanleitung

W a t e r o u t l e t
W a t e r o u t l e t
The water collecting container of the air dehumidifier is
equipped with a float switch which turns off the device when
the collecting container is full.
After 45 seconds, compressor and fan will automatically
stop, and an acoustic signal will sound. The
the fault code E4 will be displayed.
Another acoustic signal will sound every 5 minutes if the
water collecting container is not immediately emptied.

Removing the water collecting container

1. Turn off the device.
2. Press on the hinged cover (1)
3. Remove the container (pos. 2) and empty is immediately.
icon and
and open it then .
4. Re-insert the container. When inserting put the draining
hose (3) into the water collecting container. Make sure that
the container is correctly positioned.
5. Close the hinged enclosure cover.
6. Restart the air dehumidifier. The
code E4 should no longer be displayed.
Icon and fault code are further displayed? Remove the
container again and re-insert it properly.

Continuous or extended operation

In the case of a high humidity of air it is recommended to
operate the air dehumidifier in continuous mode. In continuous
mode it is not needed to empty the water collecting container.
Proceed as follows:
1. Remove the water collecting container from the device.
2. Put the draining hose (3) through the hole
enclosure and pull it out of the device on the other side
.
3. Re-insert the collecting container in the device.
4. Close the hinged enclosure cover.
5. Place a large collecting container below the water draining.
Or:
Extend the water draining using a garden hose to pipe the
water into a drain channel.
icon and the fault
in the
15