Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL KH 1800 Originalbetriebsanleitung

Anleitung_KH_1800_SPK7__ 27.02.13 13:07 Seite 10
GB
7.2 Heat output switches (Fig. 2):
Off setting (OFF)
n
Fan setting (FAN)
n
Low heating output (LOW - 1200 W)
n
Maximum heating output (HIGH - 1800 W)
n
7.3 Thermostat control (Fig. 2 / Item 5):
Switch on the required heating output. Turn the control
to "HIGH" until the required room temperature has
been reached. Then turn down the control until you
hear a clear click. The thermostat control will switch
the radiator on and off automatically to maintain the
room temperature at an almost constant level.
However, this presupposes that the radiator has
sufficient output to cover the heating requirements for
the room.
7.4 Overheating guard
In case of excessive heating, the heating function will
shut down automatically. The fan and the indicator
light (Fig. 1 / Item 1) will remain on.
If the overheating guard has triggered, the „Caution"
indicator light (Fig. 1 / Item 2) will be lit. If this occurs,
turn off the equipment, disconnect the mains plug and
wait a few minutes for the equipment to cool. After
eliminating the cause (e.g. a covered air grille), the
equipment can be switched on again. If the
overheating guard triggers repeatedly, please contact
your customer service center (in Germany ISC
GmbH).
8. Cleaning, maintenance and ordering
of spare parts
8.1 Cleaning
Before carrying out any cleaning and
n
maintenance work the equipment must be turned
off, disconnected from the power supply and
cooled down.
Use a damp cloth to clean the casing.
n
Remove dust pollution with a vacuum cleaner.
n
8.2 Servicing
Maintenance and repair work may only be carried
n
out by an electrical servicing contractor or ISC
GmbH.
Check the mains lead at regular intervals for signs
n
of defects or damage. A damaged mains lead
may only be replaced by an electrician or ISC
GmbH in compliance with the relevant
regulations.
There are no parts inside the equipment which
n
require additional maintenance.
10
8.3 Ordering spare parts
Please provide the following information on all orders
for spare parts:
Model/type of the equipment
n
Article number of the equipment
n
ID number of the equipment
n
Part number of the required spare part
n
For our latest prices and information please go to
www.isc-gmbh.info
9. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.

10. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.