Clock Functions - IKEA GRÄNSLÖS Handbuch

ENGLISH
Heat-up indicator
When you activate an oven function, the
bars in the display

Clock functions

Clock functions table
Clock function
TIME OF DAY
MINUTE MINDER
DURATION
END
Press again and again to
switch between the clock
functions.
To confirm the settings of the
clock functions, press
seconds for an automatic
confirmation.
Setting the DURATION or END function
during cooking function
1. Press again and again until the
display shows
or flashes in the display.
2. Press or to the set the values and
press to confirm.
come on one by one.
To set, change or check the time of day. Refer to "Set-
ting the time".
Use to set a countdown time (maximum 23 h 59 min).
This function has no effect on the operation of the ap-
pliance. You can set the MINUTE MINDER at any time,
also if the appliance is off.
To set how long the appliance operates. Use only when
an oven function is set.
To set when the appliance must deactivate. Use only
when an oven function is set. You can use Duration and
End at the same time (time delay), if the appliance is to
be activate and deactivate automatically later.
or wait 5
or .
The bars show that the oven temperature
increases or decreases.
Application
For Duration first you set the minutes
and then the hours, for End
the hours and then the minutes.
An acoustic signal sounds for 2 minutes
after the time ends.
time setting flash in the display. The oven
stops.
3. Press any button to stop the acoustic
signal.
If you press
hours for DURATION
appliance goes to setting of the
END function.
first you set
or symbol and
when you set the
, the
12