Inhaltsverzeichnis
Werbung
Upon completion of editing the task, the task list will show the distances for each leg,
and the start gate will be shown with an S, end of speed section is shown with an E and
the goal shown with a G. The completed task should look like Figure 7.1
Abbildung 7.1 – Task Beispiel
Progressing through the above procedure sets the task on the instrument. Going back
into the Flight Mode Screen, by pressing MENU bottom will automatically activate the
task and start navigation. Warning: After the route is edited navigation will be restarted
at the beginning of the route. Consider the same task represented in Figure 4.5, but
now the End of Speed Section (ESS) is a cone with 4:1 ratio. In order to set up the task
you should make the same steps defined in Section
5.1
except the step 5. As the cone
as a ratio of 4:1 in this step you should set the Cone parameter to 4.0. The LIVE-SD
provides some information to optimize the navigation when the ESS is conical. This
information is provided through 5 additional data fields which can be included in a
Layout page. Each of the data fields is explained in Section 3.2, but for a better
understanding consider the situation of Figure 5.2.
Abbildung 7.2 – Conical End of Speed Section
78
Werbung
Inhaltsverzeichnis
