IKEA enastaendew Handbuch Seite 12

ENGLISH
4
Setting and starting a programme
Setting mode
The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when, af-
ter the activation the display shows 2 hori-
zontal status bars.
If the control panel shows other conditions,
press the cancel button until the appliance
is in setting mode.
Starting a programme without delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode.
3. Set the programme.
• The related programme number
flashes in the display.
4. If you want, you can set the options.
5. Close the appliance door. The pro-
gramme starts.
• If you open the door, the display
shows the programme duration that
decreases with steps of 1 minute.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button again and again
until the display shows the delay time
you want to set (from 1 to 24 hours).
• The delay time flashes in the display.
• The delay indicator is on.
5
If the programme
has a prewash
phase, put a small
quantity of deter-
gent on the inner
part of the appli-
ance door.
3. Close the appliance door. The count-
down starts.
• If you open the door, the display
shows the countdown of the delay
start that decreases with steps of 1
hour.
When the countdown is completed, the pro-
gramme starts.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while the
countdown operates
Press the cancel button until the display
shows 2 horizontal status bars.
When you cancel a delay start, the ap-
pliance goes back to setting mode.
You have to set the programme again.
Cancelling the programme
Press the cancel button until the display
shows 2 horizontal status bars.
Make sure that there is detergent in
the detergent dispenser before you
start a new programme.
At the end of the programme
When the programme is completed, an in-
termittent acoustic signal operates. The dis-
play shows 0 and the end indicator comes
on.
1. Press the on/off button to deactivate the
appliance.
2. Close the water tap.
If you do not press the on/off button, the
AUTO OFF device automatically deacti-
vates the appliance after some minutes. This
helps to decrease the energy consumption.
Let the dishes become cold before you
remove them from the appliance. Hot
dishes can be easily damaged.
First remove the items from the lower
basket, then from the upper basket.
12