On machines with Water Stop
Screw off the hose at the tap, place it in a bowl,
switch on any optional wash programme and terminate
after approx. 40 seconds using the quick wash button.
The residual water will flow out from the water inflow
hose, let the water run into the bowl.
Screw the hose back onto the tap.
Cleaning the detergent drawer
1.
Pull the detergent drawer out until it stops.
2.
Press down in the middle of the softener section cover,
and pull the drawer all the way out.
3.
Remove the divider.
4.
Clean the chambers and insert under running water.
5.
Replace the divider in the detergent drawer.
47
6.
Replace the drawer in the machine.
Emergency emptying
Emergency emptying is necessary if:
The error message «Check water outlet» appears.
The pump is blocked by a foreign body (e.g. buttons,
paper clip, fluff) and the water cannot be pumped out.
Up to 20 litres can flow from a blocked pump.
Have a bucket ready.
Risk of scalding! Allow hot detergent solution to cool.
Emptying procedure
1.
Switch off the mains power supply
2.
Open the maintenance hatch at the machine front
3.
Push the flat container underneath the maintenance
hatch.
Loosen the pump cover slightly and allow the residual
water in the machine to drain off into the container.
Empty the container when full. If required repeat the
process several times, until all water has drained off.
Attention: Only open pump cover stepwise, danger of
flooding.
4.
Remove the pump cover. Remove foreign bodies and
deposits of fluff. Clean the pump interior. It must be
possible to rotate the pump impellers. Screw on the
pump cover.