Din Front/Rear-Mount; Before Installing The Unit; Din Front-Mount; Installation With The Rubber Bush - Pioneer AVHP6600DVD Installationsanleitung

DIN Front/Rear-mount

This unit can be properly installed
either from "Front" (conventional DIN
Front-mount) or "Rear" (DIN Rear-
mount installation, utilizing threaded
screw holes at the sides of unit chas-
sis). For details, refer to the following
illustrated installation methods.

Before installing the unit

• Remove the frame and the hold-
er. (Fig. 14)
Pull out to remove the frame and then
loosen the screws (2 × 3 mm) to
remove the holder. (When reattaching
the frame, point the side with a groove
downwards and attach it.)
Holder
Screw (2 × 3 mm)

DIN Front-mount

Installation with the rubber bush

1. Decide the position of the side
brackets. (Fig. 15)
When installing in a shallow space,
change the position of side brackets. In
this case, stick conceal tape on parts
that protrude from the dashboard.
Flush surface screw (5 × 6 mm)
2. Install the unit into the dash-
board. (Fig. 16)
After inserting the holder into the
dashboard, then select the appropriate
tabs according to the thickness of the
dashboard material and bend them.
(Install as firmly as possible using the
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
Dashboard
Frame
Fig. 14
53
• After installing the unit into the
Side bracket
182
Rubber bush
Holder
Side bracket
Screw (2 × 3 mm)
dashboard, reattach the frame.
Conceal tape
Fig. 15
Screw
Fig. 16
12