Hartan Racer Plus Bedienungsanleitung Seite 16

Instructions
Unfolding the pram
By pushing the lock buttons 4, unfold the upper section to bring the handle in
horizontal position. Pull handle 1 upwards until handle catch 2 has engag-
ed.WARNING! Before using the pram, make sure all catches are locked.
Folding the pram
Turn safety turn-lock 3 inward until the handle's catch 1 has released. Push
handle downwards to fold the pram. By pushing the lock buttons 4, fold the
handle's upper section inward.
WARNING!
unfolding the chassis, and adjusting the backrest, as there is a risk that you do
yourself an injury such as jamming your limbs, fingers, etc.
Height adjustment of handlebar
Press the two handle-folding lock buttons 4 to bring the upper section of the
handlebar 1 in the desired position.
Changing of wheels
Release the parking brake. Push the button 5 to release the retention, and pull
off the wheel. Push the wheel right to the axle's stop, then depress the button.
Make sure, all wheels are held in place properly.
Lock-type-swivel wheels
Turn down the lock lever 6 to pre-select the straight-line motion mode, which
will be activated as soon as any wheel starts to point in forward direction. The
lever 6 will act on both the right and left wheels as well. To allow the wheels to
swivel freely again, turn the lever 6 back to the horizontal position until it snaps
into place.
ATTENTION!
Remember to clean the wheel blocks on a
regular basis depending on the dirt accumula-
tion degree. Dirt, sand, muddy water, salty
slush, etc. may cause a deposit accumulating
inside the sleeves, and thus restricting the swi-
velling movement. Clean the guiding pin as well
as the guiding and locking sleeve using a damp
cloth. If necessary, rinse them out with clear
water, rub them dry, and spray them using a
silicone based lubricant. Do not use oil!
When cleaning the wheel block, press down
the metal clamp to separate the halves and
pull off the lower section.
12
We recommend proceeding with caution when folding and
IMPORTANT!
Locking sleeve
Arretierhülse
Guiding sleeve
Führungshülse
A
B
Demontage
Dismounting
Depress metal clamp (A)
A Metallklammer drücken
and pull off wheel block
und B gleichzeitig
(B).
Radblock abziehen.
Guiding pin
Führungszapfen
B
A
Montage
Mounting
Depress metal clamp (A)
A Metallklammer drücken
and slide on wheel block
und B gleichzeitig
(B).
Radblock aufstecken.