Reich easydriver basic 2.8 Bedienungsanleitung Seite 32

Trailer battery LED, red

Symbol not lit up: Battery voltage is in
order

Slow flashing: Batteries
charged

1x per second, continuous flashing and 3x
acoustic warning: Batteries almost empty.
Charging is essential!

LED permanently on and 10x acoustic
warning: Batteries deeply discharged. The
battery should be charged as soon as
possible, so that it does not get damaged.
5x acoustic warning and LED flashing in red:

T emperature of the base station is too
high. All driving functions are switched off.
Let the base station cool down! The sys-
tem can again be switched on once the
base station has cooled down.
10x acoustic warning and LED permanently
red:

Slave base station not found. Check the
voltage supply and the connection cable
when Version 3.1 is used.
Overload indicator LED, red

Symbol not lit up: Current flow through the
base station is in order

Symbol permanently lit up and acoustic
warning: Overcurrent detection. All driving
functions are switched off. Reactivate the
system by switching the remote control Off
and On.
Radio range indicator LED, red

Symbol not lit up: Radio range is in order

1x per second flashing: Radio range ex-
ceeded. All driving functions are switched
off. Reactivate the system by switching the
remote control Off and On.
Appendix A1
A1 Synchronisation
Synchronisation must be performed in the event of a
should be
functional fault or following the exchange of electronic
parts. Proceed as follows:
Switch OFF the remote control
(= press once) as required
Switch ON the remote control (= press 2x)
Keep the forwards AND backwards button
pressed during the self-test. A constant
sound signal is produced and the trailer
symbol of the remote control flashes.
The sound signal goes off and the trailer
symbol lights up permanently once syn-
chronisation has been completed. Release
the forwards and backwards buttons. A
short sound signal is produced. The base
station and the remote control are now
synchronised with each other.
The synchronisation is completed.
The remote control will switch OFF after approx. 60
seconds when no input is provided!
Switch off the base stations as
well.
Switch on the base stations
GB11