Replacing The Lamp; Closing The Door - Novamatic EKI1226-IB Benutzerhandbuch

63
Problem
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the dis-
play.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.

Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
The FastFreeze or Intensi-
veCooling function is
switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised
Service Centre.
Solution
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off FastFreeze or Inten-
siveCooling manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FastFreeze or In-
tensiveCooling function".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and display
shuts off for a short time.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.