Novamatic EK617RE Benutzerhandbuch Seite 11

11
Problem
There is too much frost and
ice.
Water flows into the refrigera-
tor.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
There is too much con-
densed water on the rear wall
of the refrigerator.
Possible cause
The FastFreeze function is
switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The FastFreeze function is
switched on.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The FastFreeze function is
switched on.
Door was opened too fre-
quently.
Solution
Refer to "FastFreeze func-
tion".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" chapter.
Clean the water outlet.
Make sure that food prod-
ucts do not touch the rear
plate.
Switch off FastFreeze man-
ually, or wait until the function
resets automatically to set
the temperature. Refer to
"FastFreeze function"
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Refer to "FastFreeze func-
tion".
Open the door only when
necessary.