Training - sportplus SP-HT-9800-iE Bedienungsanleitung

6. USING THE COMPUTER
ERROR MESSAGES
Display Cause
E1 (ERROR 1) The computer does not receive any position signal from the
actuator (67), or the movement of the motor has been blocked.
• Check the wiring of the product for any damage or jamming.
• Check the movement range of the brake for any blockage.
• Please contact our customer service.
E2 (ERROR 2) The system cannot recall the program data from the memory.
• The computer must be replaced.
• Please contact our customer service.
E3 (ERROR 3) The actuator does not move to the designated position.
• Replace the actuator.
• Please contact our customer service.
SP-HT-9800-iE-IM-DE+GB+FR-04.indb 44-45
44

7. TRAINING

TIPS FOR YOUR WORKOUT
All recommendations in this manual are intended exclusively for healthy persons and not for
persons with heart/cardiovascular problems!
All tips are intended only as rough suggestions for a training program. If necessary, consult
your physician for tips that meet your personal requirements. The following pages will explain
exactly how to operate your new training device and will illustrate the fundamentals of fitness
training. In order to reach your desired training goal, it is imperative to inform yourself about
important points for creating a training program in general and about the exact way to operate
your Ergometers using this manual as a guide. Therefore, please thoroughly read all of the points
listed here and pay them close attention.
DESIGNING A TRAINING PROGRAM
In order to achieve noticeable physical and health improvements, the following factors have to
be considered before determining the necessary training effort.
INTENSITY
The level of physical strain during training must exceed the normal burden without reaching a
point of breathlessness or exhaustion. A suitable guideline for effective training is your pulse.
WARNING!
Over-exercise may result in serious injury or death. If you feel faint stop exercising
immediately.
PHASES OF TRAINING
Each training session should consist of 3 training phases:
• "Warm-up phase"
• "Training phase"
• "Cool-down phase"
In the "warm-up phase", your body temperature and oxygen intake should slowly increase.
This can be achieved with gymnastic exercise or stretches lasting from 5 to 10 minutes. A list of
exercises for properly stretching your leg muscles can be found on the following pages. After the
warm-up, the real training should begin ("training phase"). Training intensity should be low for
the first few minutes and should then increase to the appropriate training intensity for a period
of 15 to 30 minutes. To ease circulation after the training phase and to prevent muscle cramps or
pulled muscles, a "cool-down phase" should follow the "training phase". During this phase, which
should be approx. 5 to 10 minutes long, carry out stretching exercises and/or light gymnastic
exercises lasting 30 seconds each.
45
10/6/2016 2:30 PM