Using The Air Damper; Some Things Worth Knowing About Firing - wiking Atomic Bedienungsanleitung

Using the Air Damper

To achieve good combustion, which results in better heating efficiency,
it is important to add the right amount of air to the fire. Air is regulated
with a user-friendly, one-lever system that is located under the stove door;
see Figure 2. The lever has a range of 20 mm, and in the table below you
can see the effect on air flow in relation to the position of the lever.
Lever's position
Pushed all the way in.
The lever is pulled out
-0 mm towards yourself.
The lever is pulled
completely out,
or -20 mm.
In Figure 3 you can see the importance of air for proper combustion.

Some Things Worth Knowing about Firing

Maximum Firing Amount
Maximum amounts per hour:
Fuel
Wood
Warning: Too much heat can destroy your wood-burning stove, the chimney and your fireplace
ducts. Therefore, if you exceed the abovementioned limits, your wood-burning stove, chimney
and fireplace duct will no longer be covered by the factory guarantee.
Effect on Air Flow
All air to the stove is shut off.
Combustion air and pane-flushing
air are supplied. Both can be
regulated by pulling the lever
-0 mm towards yourself.
Primary air is supplied and can be
regulated.
The right amount
No primary
of primary and
air supply
secondary air supply
Used for
This setting must only be used when
the wood-burning stove is completely
shut off, such as during cleaning.
This setting is only to be used when
the wood has completely caught fire,
and when you want the best use of
the wood.
This setting is always to be used
when lighting a cold stove and firing
new wood.
No secundary
air supply
Fig. 3
Maximum amount per hour
3.0 kg
English
Fig. 2
25