Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need a PAR-30 230-240V/100W E27 lamp.
Procedure:
Step 1: Remove the color filter frame from the device (see drawing below).
Step 2: If replacing the lamp, remove the old lamp from the socket.
Step 3: Insert the PAR-30 230-240V/100W E27 lamp into the lamp-socket.
Step 4: Replace the color filter frame onto the device.
Installing/Replacing the color filter frame
Overhead rigging
The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Do not operate this device without color filter frame!
16/35
41600160_V_1_0.DOC
Werbung
Inhaltsverzeichnis
