Overview; Installation; Installing/Replacing The Lamp - EuroLite PAR-64 PROFI SPOT SET Bedienungsanleitung

OVERVIEW

INSTALLATION

Installing/Replacing the lamp

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need you need one PAR-64 pressed-glass lamp with up to max. 1000 W or a raylight
reflector with a GY-9.5 lamp socket with up to max. 500 W.
Remove the wrapping material at the tube rear before operating this device!
Procedure:
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
14/34
(1) Housing cover
(2) Mounting-bracket
(3) Extension spring
(4) Hole for safety rope
(5) Tube
(6) Colour filter frame
(7) Silicone cable
(8) Mounting bracket screws
(9) Hole for safety rope for
colour filter frame
(10) Clip-to-hold clamps
00030027.DOC, Version 2.1