Closing The Door; Installation; Electrical Connection; Ventilation Requirements - Electrolux ERN2214FOW Benutzerhandbuch

26 www.electrolux.com

6.2 Closing the door

1. Clean the door gaskets.
2.
If necessary, adjust the door. Refer to

"Installation".

7. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
SN
N
ST
T

7.3 Ventilation requirements

Refer to the assembly instructions
for the installation.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
min.
200 cm
2
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.

7.2 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
contact for this purpose. If the domestic
power supply socket is not earthed, con-
nect the appliance to a separate earth in
compliance with current regulations, con-
sulting a qualified electrician.
The manufacturer declines all responsibili-
ty if the above safety precautions are not
observed.
This appliance complies with the E.E.C.
Directives.
The airflow behind the appliance must be
sufficient.
min.
200 cm
2