Assembling The Handle Bar; Mounting And Emptying The Collection Bag; Exchanging The Cylinder - FLORABEST FLV 1200 B1 Originalbetriebsanleitung

Assembling the handle
bar
1. Insert the lower bar (7) into the
A
implement case (8) and screw
it on with the two Philips screws
(22).
2. Use the screws and the wing nuts
(4b) to attach both central bars
(15) to the lower bar (7).
3. Hang the cable strain relief (18)
on the upper handle bar (3).
4. Use the screws and the wing nuts
(4a) to attach the upper bar (3) to
both central bars (15).
5. Fasten the machine cable (19)
with the machine cable clip
(12/16) to the bar.
6. Attach the tool retainer (14) and
clip the tool key (13).
Mounting and emptying
the collection bag
WARNING: Never operate the
implement without the impact
protector. Danger of Injury!
Recommendation: Work with the
collection bag for aerating and
without the collection bag for
verticuting
Assembling the collection bag:
The collection bag is delivered in a folded
state and must therefore be assembled
before it is mounted on the implement.
1. Pull the collection bag over the
C
frame (23).
2. Pull the collection bag's plastic
straps over the frame's rods
and clip them in.
Mounting the collection bag on the
implement:
3. Lift the impact protector (6).
4. Push the pins on the collection
bag rods into the socket in the
implement case.
5. Release the impact protector so
that it holds the collection bag (5)
in its position.
Removing and emptying the collection
bag:
6. Lift the impact protector (6) and
take out the collection bag (5).

Exchanging the cylinder

Switch off the implement, disconnect
the mains plug and wait until the
cylinder is standing still.
Wear gloves when handling the
cylinder.
1. Turn the implement over.
E
2. Remove any grass or debris from
either end of the mounted
cylinder to ensure no foreign
objects hinder reassembly.
3. Take the spanner (
the holder (
4. Loosen the fastening screws and
pull the bearing support
upwards.
5. Tilt the cylinder (
F
upwards and pull the shaft out of
the square receptacle (24).
6. Insert the new cylinder (
20/21) by reversing the
sequence.
GB IE
13) out of
A
14).
A
20/21)
A
A
39