Boiling Water - Silvercrest IAN 96824 Bedienungsanleitung

Boiling water

RISK - ELECTRICAL SHOCK!
Never place the electrical base 3 close to water – this would be a
►
potentially fatal risk!
WARNING - RISK OF INJURY!
► Always use freshly drawn water. Do not consume any water that has already
stood in the kettle for longer than one hour. Do not reboil water that has cooled
down. Always pour old water away. Microbes could have formed in it!
NOTE
Always ensure that the ON/OFF switch 2 is turned to "O" when the
►
mains plug is unplugged and the device is standing on the base 3.
If not, the device could heat up unintendedly as soon as the mains plug is
plugged in again.
1) Lift the kettle off of the base when fi lling it!
2) Press the unlocking button 1 and open the lid.
NOTICE
► When fi lling it, hold the kettle upright. Only in this way can you correctly
read the markings on the scale 5.
3) Fill the kettle...
–
–
4) First close the lid and then place the kettle on the base 3 such that it sits
securely on the base 3.
5) Now insert the plug into the mains power socket.
6) Press the ON/OFF switch 2 downwards so that it engages.
7) The integrated indicator light in the ON/OFF switch 2 indicates that the
appliance is now heating up.
8) The appliance switches itself off and the control lamps go out as soon as
the water is on the boil. The ON/OFF switch 2 springs out.
WARNING - RISK OF INJURY!
► For safety reasons, the lid should not be opened while the water is boiling
or is very hot. There is a risk of receiving severe scalds.
SWKCD 3000 A1
to at least the MIN mark, so that the appliance does not overheat,
to no higher than the MAX mark, so that boiling water cannot spill out.
GB
MT
19